Home | About us | Editorial board | Search | Ahead of print | Current issue | Archives | Submit article | Instructions | Subscribe | Advertise | Contacts | Login 
  Users Online: 471 Home Print this page Email this page Small font sizeDefault font sizeIncrease font size  

 Table of Contents  
Year : 2016  |  Volume : 6  |  Issue : 1  |  Page : 3-7

Analytic hierarchy process as module for productivity evaluation and decision-making of the operation theater

1 Department of ENT, Faculty of Medicine, Al-Azhar University, Cairo, Egypt
2 Department of Rheumatology, Faculty of Medicine, Al-Azhar University, Cairo, Egypt

Date of Web Publication8-Jan-2016

Correspondence Address:
Abdelrahman E. M Ezzat
Department of ENT, Faculty of Medicine, Al-Azhar University, Cairo
Login to access the Email id

Source of Support: None, Conflict of Interest: None

DOI: 10.4103/2231-0770.173579

Rights and Permissions

The analytic hierarchy process (AHP) is a theory of measurement through pairwise comparisons and relies on the judgments of experts to derive priority scales, these scales that measure intangibles in relative terms. The aim of the article was to develop a model for productivity measurement of the operation theater (OT), which could be applied as a model for quality improvement and decision-making. AHP is used in this article to evolve such a model. The steps consist of identifying the critical success factors for measuring the productivity of OT, identifying subfactors that infl auence the critical factors, comparing the pairwise, deriving their relative importance and ratings, and calculating the cumulative effect according to the attributes in OT. The cumulative productivitycan be calculated by the end and can be compared Ideal productivity to measure the productive of OT in percentage fraction. Hence, the productivity could be calculated. Hence, AHP is a very useful model to measure the productivity in OT.

Keywords: Analytic hierarchy process, decision-making, operating theater, performance measures, productivity

How to cite this article:
Ezzat AE, Hamoud HS. Analytic hierarchy process as module for productivity evaluation and decision-making of the operation theater. Avicenna J Med 2016;6:3-7

How to cite this URL:
Ezzat AE, Hamoud HS. Analytic hierarchy process as module for productivity evaluation and decision-making of the operation theater. Avicenna J Med [serial online] 2016 [cited 2021 Jan 16];6:3-7. Available from: https://www.avicennajmed.com/text.asp?2016/6/1/3/173579

   Introduction Top

The analytic hierarchy process (AHP) is a general theory of measurement. They are derived by making pairwise comparisons using numerical judgments from an absolute scale of numbers. This is essential when both subjective and objective factors need to be considered in the same pool.[1] AHP provides a way to derive and synthesize relative scales systematically. The various factors are arranged in a hierarchy and measured according to the factor and subfactor represented within these structures. It is used to derive ratio scales from both discrete and continuous paired comparisons.[2]

These comparisons may be taken from actual measurements or from a fundamental scale which reflects the relative strength of preferences and feelings. The AHP has a special concern with departure from consistency, its measurement, and on dependence within and between the groups of elements of its structure. Some key and basic steps involved in this methodology are: [3],[4]

  • Define the problem
  • Broaden the objectives of the problem or consider all actors, objectives, and its outcome
  • Identify the criteria that influence the behavior
  • Structure the problem in a hierarchy of different levels constituting goal, criteria, subcriteria, and alternatives.

The AHP has found its widest applications in multi-factors decision-making, planning, and resource allocation (MFDA), and in conflict resolution.[5] The AHP is a method which incorporates benefits and risks, explicitly by combining the importance of differences in probabilities of outcomes related to alternatives and the weighting of the importance of those outcomes.[6],[7] MFDA techniques can be used to structure complex decisions and improve the transparency of the decision-making process.[8]

Hence, our aim was to develop a model for productivity measurement of the operation theater (OT), which could be applied as model for quality improvement and decision-making.

   Research Methodology Top

The suggested module of analytic hierarchy process for measuring productivity of operation theater

Step 1

Broaden the objectives of the problem (calculation of the productivity of OT) and goal (effective and efficient OT).

Identify the criteria that influence the productivity (input factors = “operating room and the teamwork” and output factors = “patient factors”). Structure the problem in a hierarchy of different levels constituting goal, criteria, subcriteria, and alternatives as shown [Figure 1] and [Table 1].
Figure 1: Hierarchy diagram of analytic hierarchy process of operation theater

Click here to view
Table 1: The factors that influence the productivity

Click here to view

Compare each element in the corresponding level and calibrate them on the numerical scale of numbers that indicates how many times more important or dominant one element is over another element with observance thefactor with respect to which they are compared. A 9-point numerical scale was used for the comparison. The intensity and the definitions of the pair wise comparison are as follows:

1 = equal importance; 2 = weak or slight; 3 = moderate importance; 4 = moderate plus; 5 = strong importance; 6 = strong plus; 7 = very strong; 8 = very, very strong; 9 = extreme importance or 1.1–1.9 if the activities are very close, according to Saaty in 1980.[2]

Step 2

The pairwise comparisons of various factors generated at step 2 are organized into a square matrix. The diagonal elements of the matrix are 1. The factor in the I row is better than factor in the J column if the value of element (I, J) is more than 1; otherwise, the factor in the J column is better than that in the I row. The (J, I) element of the matrix is the reciprocal of the (I, J) element.

Step 3

The principal eigenvalue and the corresponding normalized right eigenvector of the comparison matrix give the relative importance of the various criteria being compared. The elements of the normalized eigenvector are termed weights with respect to the criteria or subcriteria and ratings with respect to the alternatives.

This is calculated as the fraction of the importance of each critical success factor with respect to the sum of the overall comparison between the factors. By the equation:

Cumulative weight (CW) = AI1 + BI2 + CI3/n, as;

n = number of rows.

For example, in [Table 2], the sum of all the values of importance (AJ) for the operating room factor is 5.333 (1 + 1/3 + 4) in J column, and the fraction of process alone will be 1 over 5.333 (0.188) and that of structure will be 1/3 over 5.333 (0.062) and 4 over 5.333 (0.745). The overall importance of the operating room factors was calculated as an average for each factor [in I row [Table 2]. Thus, cumulative priorities for operating room factor (0.188 + 0.077 + 0.058 divided by 3), which equal 0.107, as shown [Table 2],[Table 3],[Table 4],[Table 5],[Table 6],[Table 7].
Table 2: Pairwise comparison matrix for the main factors

Click here to view
Table 3: Pairwise comparison matrix of the operating room subfactors with respect to the goal

Click here to view
Table 4: Pairwise comparison matrix of the main criteria with respect to the goal

Click here to view
Table 5: Pairwise comparison matrix of the teamwork subfactors with respect to the goal

Click here to view
Table 6: Pairwise comparison matrix of nursing skills, surgical skills, and surgical skills subfactors with respect to the goal

Click here to view
Table 7: Pairwise comparison matrix of nonsurgical skills subfactors with respect to the goal

Click here to view

Step 4

For all the subfactors, nine attributes were identified, namely excellent/very good/good/above average/average/below average/not poor/poor/very poor. For each subfactor, the excellent attribute received a weight of 0.9, the above average weight of 0.6, and the very poor weight of 0.1, as shown in [Figure 1].

Step 5

The rating of each alternative is multiplied by the weights of the subfactor and aggregated to get local ratings with respect to each factor. The local ratings are then multiplied by the weights of the factor and aggregated to get cumulative productivity. The AHP produces weight values for each alternative based on the judged importance of one alternative over another with respect to a common factor.

   Results Top

The cumulative productivity could be calculated by the end and could be compared with Ideal productivity. Hence, the productivity could be calculated through the equation:

After the process of paired comparisons, decision-making could be started according to the weight of each factor and subfactor.

   Discussion Top

The productivity of operating rooms is one of the main problems facing by health economics. By considering exclusively an economic point of view, this investment is usually balanced by the benefits derived to the patient and the service provider. The OT also account for about 40% of the hospital's total expenses which include manpower costs (i.e., salaries of surgeons, anesthetists, nurses, etc.).[9]

Productivity provides valuable information on how an OT is performing, where it would like to be, and how it can achieve its goals.[10] It is generally defined as the ratio of units of outputs to units of inputs.[11] Oh et al. on calculating the productivity ratio stated that “it is simple in the case of a single-input, single-output firm.” For a single-input, single-output firm productivity (P) can be defined as: (P = Y/X) where Y is the number of units of the firm's single-output and X is the number of units of the firm's single-input.[12] However, for the more realistic case of a multiple-input, multiple-output firm, calculating the productivity ratio is significantly more difficult and less objective. Multiple factors should be measured if we are calculating the productivity of OT, as it depends on the performance of both OT itself and the teamwork.[13] Our present model attempts to achieve this link by having measures for all those parameters (hospital factor, patient factors, and the teamwork factors) using the weight of each factor and subfactor relatively to each other, either they are subjective or objective factors. Hence, AHP is one of the important tools to evaluate the productivity.

The traditional health-care decision-making tools are largely viewed as tools that inform health professionals' or health-care organizations' decisions instead of stimulating patient involvement. Involving patients in the decision-making process could make a potentially significant difference in health outcomes and reduce the cost of care. It is worth nothing that patients' involvement is not intended to transfer power to patients, but to endorse the decisions of clinicians and policymakers. As such, mechanisms to involve patients in decision-making processes need to be established.[11]

The process of paired comparisons has far broader uses for making decisions. Saaty stated that “we can deal with a decision from four different standpoints: The benefits (B) that the decision brings, the opportunities (O) it creates, the costs (C) that it incurs, and the risks (R) that it might have to face.” He referred to these merits together as BOCR.[2]

The alternatives could be ranked for each of the four merits. The four rankings are then combined into a single overall ranking by rating the best alternative in each of the BOCR on strategic factor or subfactor that an individual or a government uses to decide whether or not to implement one or the other of the numerous decisions that they face.

Ritrovato et al. compared the core model with integrating the multicriteria decision-making analysis using the AHP supplies a more timely as well as contextualized evidence, making it possible to obtain data that are more relevant and easier to interpret, and therefore more useful for decision makers to make investment choices with greater awareness.[13],[14]

   Conclusion and Recommendation Top

The productivity in the OR do not depend only on the hospital, patient or the teamwork skill factors (they are either objective or subjective), so it is not easy to be measure because the complexity of what we measure and the interaction between them. The productivity needs a calculation method, and AHP has a sound mathematical basis and its application is user-friendly.

Hence, AHP is a valuable tool to design a model to elect the cumulative productivity and the productivity percentage and to make a decision in OT. It could be used to compare it with another or with the standard one. Moreover, it could enable us to identify the deficiencies in the specific areas.

Financial support and sponsorship


Conflicts of interest

There are no conflicts of interest.

   References Top

Saaty TL. Decision making with the analytic hierarchy process. Int J Serv Sci 2008;1:83-98.  Back to cited text no. 1
Saaty TL. The Analytic Hierarchy Process. New York: McGraw-Hill; 1980.  Back to cited text no. 2
Forman EH, Gass SI. The analytical hierarchy process – An exposition. Oper Res 2001;49:469-87.  Back to cited text no. 3
Vaidya OS, Kumar S. Analytic hierarchy process: An overview of applications. Eur J Oper Res 2006;169:1-29.  Back to cited text no. 4
Saaty TL. Group Decision Making and the AHP. New York: Springer-Verlag; 1989.  Back to cited text no. 5
Dolan JG, Isselhardt BJ Jr., Cappuccio JD. The analytic hierarchy process in medical decision making: A tutorial. Med Decis Making 1989;9:40-50.  Back to cited text no. 6
Liberatore MJ, Nydick RL. The analytic hierarchy process in medical and health care decision making: A literature review. Eur J Oper Res 2008;1:194-207.  Back to cited text no. 7
Saaty T. Fundamentals of Decision Making and Priority Theory with the Analytic Hierarchy Process. Pittsburgh, PA: RWS Publications; 2006.  Back to cited text no. 8
Macario A, Vitez TS, Dunn B, McDonald T. Where are the costs in perioperative care? Analysis of hospital costs and charges for inpatient surgical care. Anesthesiology 1995;83:1138-44.  Back to cited text no. 9
Ezzat AE, Hamoud HS. How to assess the productivity of operating rooms? Int J Health Sci Res 2014;4:261-7.  Back to cited text no. 10
Sherman D, Zhu J. Service Productivity Management: Improving Service Performance Using Data Envelopment Analysis (DEA). Boston: Springer; 2006.  Back to cited text no. 11
Oh H, Phua T, Tong S, Lim J. Assessing the performance of operating rooms: What to measure and why? Process Singapore Health Care 2011;20:105-9.  Back to cited text no. 12
Adunlin G, Diaby V, Xiao H. Application of multicriteria decision analysis in health care: A systematic review and bibliometric analysis. Health Expect 2014. [Epub ahead of print].  Back to cited text no. 13
Ritrovato M, Faggiano FC, Tedesco G, Derrico P. Decision-oriented health technology assessment: One step forward in supporting the decision-making process in hospitals. Value Health 2015;18:505-11.  Back to cited text no. 14


  [Figure 1]

  [Table 1], [Table 2], [Table 3], [Table 4], [Table 5], [Table 6], [Table 7]


    Similar in PUBMED
   Search Pubmed for
   Search in Google Scholar for
 Related articles
    Access Statistics
    Email Alert *
    Add to My List *
* Registration required (free)  

  In this article
   Research Methodology
    Conclusion and R...
    Article Figures
    Article Tables

 Article Access Statistics
    PDF Downloaded337    
    Comments [Add]    

Recommend this journal